Ht-instruments MACROTEST G3 Manuel d'utilisateur télécharger pdf (Page 75)

MACROTESTG3 - COMBIG3

EN - 74

Press the GO/STOP key on the instrument to measure

the Z2 impedance and complete the V% voltage drop

measurement. During this whole stage, do not

disconnect the measuring leads of the instrument from

the system being tested

In case of positive result (maximum percentage value

of calculated voltage drop according to § 12.11 <

set limit value), the screen to the side is displayed by

the instrument, which contains the value of the Z2 end

of line impedance together the Z1 (Offset) value.

Press the SAVE button or touch the icon to save

the measurement (see § 7.1)

In case of negative result (maximum percentage

value of calculated voltage drop according to §

12.11 > set limit value), the screen to the side is

displayed by the instrument, which contains the value

of the Z2 end of line impedance together with the Z1

(Offset) value. Press the SAVE button or touch the

icon to save measurement (see § 7.1)

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 107 108

Pas de commentaire

Ht-instruments MACROTEST G3 Manuel d'utilisateur Page 75