Ht-instruments QUICKLAN6050 Manuel d'utilisateur télécharger pdf (Page 29)

QuickLAN 6050

EN - 10

6.3. WIRE MAP CHECKING

Use the tester wire map function and remote identifier unit (ID), to determine the wiring

status of both the near end and far end of the cable. Wire Map measuring procedure:

1. Select cable type under test.

2. Connect the cable under test to the appropriate connectors on the tester and on the

identifier.

3. Press WIRE MAP key.

Fig. 6: Good cable

Failure Display Wiring Description

Short (near end)

Alternately display an “s” with

actual wire number of each wire

shorted.

Open

Alternately display “o” with the

number of each open wire.

Miswire

2 2

Displays the wiring detected by

the test tool and flash the wire

numbers involved in the

anomaly.

Tab. 2: Wire map failure

6.4. DATA MEMORY AND READ OPERATING

How to store data in the memory:

1. Perform the test.

2. Press MR key each time, LCD shows M and memory location numbers (01 to 99).

How to recall data stored in the memory:

1. Press MR key for 3 seconds to enter the read memory data mode, LCD shows R and

memory location numbers, additional information can be viewed with the ▲ ▼key.

2. Press  key to scroll through the logged readings.

3. Press MR key again to exit READ mode, LCD will show “Out r EAD”.

How to delete data stored in the memory:

1. Press

key to turn off the meter.

2. Press and hold down MR key then press

key to turn on the meter, until LCD shows

“dEL”, press ▲▼ key to cycle display “YES” or “NO”, select “YES” and press  key to

cleared all memory.

1 2 ... 24 25 26 27 28 29 30 31 32

Pas de commentaire

Ht-instruments QUICKLAN6050 Manuel d'utilisateur Page 29