Ht-instruments FULLTEST3 Manuel d'utilisateur Page 65

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 92
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 64
FULLTEST 3
EN - 64
6.5.2. LIMIT CONTACT VOLTAGE menu
This menu shall be used in order to select limit contact voltage which is used in RCD and in RA
measurements. The voltage may be either 25 or 50 V.
50 V25 V
CONTACT VOL.
Figure 57: CONTACT VOL. menu
Select wished limit contact voltage by pressing appropriate touch-screen key, the menu will turn to
SETUP menu.
6.5.3. DATE/TIME menu
In order to set date and time DATE/TIME menu shall be used.
Figure 58: DATE/TIME menu
Enter actual date and time by using the , and
0
...
9
keys. Confirm it by pressing the ENTER
touch-screen key. Time starts to run on this confirmation.
6.5.4. RESET menu
There are many adjustable parameters in the FULLTEST 3 tester. If an operator due to any reason
wishes to reset all adjustable parameters to factory-set values, the operation can be done by using the
RESET menu.
Confirm RESET operation by pressing the YES touch-screen key or press the EXIT hard key to exit the
menu. Turn the tester off and on again by using the ON/OFF mains switch.
Vue de la page 64
1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 91 92

Commentaires sur ces manuels

Pas de commentaire