Ht-instruments MACROTEST G3 Manuel d'utilisateur télécharger pdf (Page 49)

MACROTESTG3 - COMBIG3

EN - 48

Press the GO/STOP key or the START key on the

remote lead. During this whole stage, do not disconnect

the measuring leads of the instrument from the system

under test.

In case of positive result (overall earth resistance lower

than the ratio between limit contact voltage and RCD

tripping current), the screen to the side is displayed by

the instrument, which contains the contact voltage

value in the secondary display.

Press the SAVE button or touch the icon to save

the measurement (see § 7.1).

6. In case of negative result (overall earth resistance

higher than the ratio between limit contact voltage and

RCD tripping current), the screen to the side is

displayed by the instrument.

Note the presence of the measurement result of the

contact voltage highlighted in red.

Press the SAVE button or touch the icon to save

the measurement (see § 7.1).

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 107 108

Pas de commentaire

Ht-instruments MACROTEST G3 Manuel d'utilisateur Page 49